Happiness is a pile of freshly clipped component leads

It’s amazing how working with electronics can bring so much fulfillment, simultaneously with so much aggravation. There was no SMMR yesterday because I was hard at work on my latest project, a function generator.


Whenever I get to solder together a circuit board, I go into soldering zen mode. Soldering a few joints, blowing away the smoke, checking my work, and clipping the leads short. That’s my favorite part. Clipping off the excess leads is so satisfying, like putting my stamp of approval on the board. Of course the moment of truth comes later, when you actually turn the thing on.

I have been wanting to put together another amplifier, but I have been lacking in decent test equipment, namely a clean signal source for testing said amplifier, so I decided to make one. Except I wanted it to be small, which means no perfboard. I didn’t have a laser printer, so I rescued one bound for the scrap pile at work, got it to print (intermittently) and got to work. Here’s the result:

Fun fact: printing your toner transfer pattern on a glossy page of Nuts & Volts produces superior toner transfer PCBs.

Amazingly, when I got everything wired up, and flipped on the power, the thing worked on the first try. I can’t speak for anyone else, but for me, powering up a brand new circuit generally results in a whole lot of nothing, followed by six hours of tracing signals through a board and swearing loudly, so I was pretty ecstatic. However…

I am getting these weird glitches at the peaks of the waveform. I’m not sure where they are coming from, but this is my current source of the aggravation I mentioned earlier. I have spent most of today trying to get rid of them, but they are very resilient and are laughing at my feeble attempts at banishing them.

Overall, I am still very happy with my new function generator. It works great for what I need, but it still needs a little bit of polishing before it is ready to publish as a project. Check back soon for deets on making your very own ultra-configurable, low(ish) distortion, 10Hz to (almost) 100kHz function generator.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>